SOUTH LYON FENCE CO.	HOW TO FENCE
	Check material list and fittings identification chart on page5. Slip tension and rail end bands on terminal posts(See figure 7).The tension bands (flat side out) should be spaced evenly. Do not spread or distort bands. All bolt heads for bands are on the outside of fence and the threaded ends are on the inside. Then apply all terminal post caps.
	FLAT GROUND Leave end corner, and gate post 2" above fabric and line post 2" below the fabric Leave end corner, and gate post 2" above fabric and line post 2" below fabric SLIGHTLY UNEVEN GROUND Leave end corner and gate post 2" above fabric and post 2" below fabric. Vary length on posts to allow for unevenness of ground, so depth in ground does not vary.   TERRACED GROUND Leave end corner, and gate post 2" above fabric and line post 2" below the fabric. A corner post assembly is used at point "A" to allow the lower portion of fence to follow thecontour of the terraced ground. SLIGHTLY ROLLING Leave end corner, and gate post 2" above fabric and line post 2" below the         UNEVEN GROUND Leave end corner, and gate post 2" above fabric and line post 2" below the fabric. A corner post assembly is used at point "A" and point "B" when the ground line rises or drops more than 15" between the posts.